Several functions of Arduino's Wire Library are used to accomplish this. In this example, two boards are programmed to communicate with one another in a Controller Reader/Peripheral Sender configuration via the I2C synchronous serial protocol. In some situations, it can be helpful to set up two (or more!) Arduino boards to share information with each other. While the above tutorials were written specifically for the Nano Family boards, they can be adopted to any Arduino board. Connecting Two Nano 33 Every Boards Through I2C.Connecting Two Nano 33 BLE Sense Boards Through I2C.Connecting Two Nano 33 BLE Boards Through I2C.See the image below to understand how to locate the correct pins on your board.Ĭheck out the following tutorials to get a more detailed step-by-step on how to use I2C on Arduino boards: For example, the pins used for MKR WiFi 1010 are D11, D12, while the pins for UNO are D18, D19. Please note that the I2C bus is attached to different pins depending on the board you are using. When this information is sent - bit after bit -, the called upon device executes the request and transmits it's data back - if required - to the board over the same line using the clock signal still generated by the Controller on SCL as timing.īecause the I2C protocol allows for each enabled device to have it's own unique address, and as both controller and peripheral devices to take turns communicating over a single line, it is possible for your Arduino board to communicate (in turn) with many devices, or other boards, while using just two pins of your microcontroller. As the clock line changes from low to high (known as the rising edge of the clock pulse), a single bit of information - that will form in sequence the address of a specific device and a a command or data - is transferred from the board to the I2C device over the SDA line. The I2C protocol involves using two lines to send and receive data: a serial clock pin (SCL) that the Arduino Controller board pulses at a regular interval, and a serial data pin (SDA) over which data is sent between the two devices. This is a journey into the world of Arm.This article was revised on 8 by Karl Söderby.

If you've come this far, I assume that you have ambitions way beyond using only the Arduino API. Learning the internals of the Due is a possible bridge from the more straightforward world of the Arduino into the much more complicated world of Arm. It uses the Arm Cortex-M3 microcontroller SAM3X8E from Microchip (formerly Atmel). The Arduino Due is quite a different beast compared to the more common Arduino Uno. This isn't a book for the faint of heart.

Due wire library